SubsTech     
SubsTech     
Command disabled: export_raw

to Metals
to Metallographic examination

Etching metallographic specimens

Dr. Dmitri Kopeliovich

Etching is the operation of revealing micro-structural features (grain boundaries, phases, precipitates and other micro-structure constituents) of the polished specimen through selective chemical attack of its surface.

  • The specimen must be washed and degreased in boiling alcohol and then cooled in running water before etching in order to prevent uneven attack and stains.
  • Clean specimen is etched by being immersion in the etching reagent for a given time. Then the specimen is quickly removed from the reagent and immediately swilled in running water.
  • The etched specimen is then visually inspected. Its surface should have slightly dull appearance (bright appearance requires additional etching).
  • Then the wet specimen should be dried in alcohol.

Etching reagents

Nital reagent: 2 volume parts of nitric acid, 98 volume parts of alcohol

Etching time: 10-30 sec.

Reveal: ferrite grain boundaries, pearlite, martensite, trostite.

Picral : saturated solution of picric acid in alcohol

Etching time: 10-30 sec.

Reveal: pearlite

- 25% aqueous solution of ammonium hydroxide with a few drops of hydrogen peroxide.

- 10% aqueous solution of ammonium persulphate.

- Saturated aqueous solution of chromic acid.

Reveal: grain boundaries.

Keller’s reagent: 1volume part of hydrofluoric acid, 1.5 volume part of hydrochloric acid, 2.5 volume parts of nitric acid, 95 volume parts water.

Etching time: 10-20 sec.

  • For nickel, monel and cobalt:

1 volume part of nitric acid, 1 volume part of glacial acetic.

1 volume part of nitric acid, 24 parts of water, 75 parts of ethylene glycol.

  • For zinc and its alloys:

1volume part of hydrofluoric acid, 99 volume parts of alcohol.

  • For lead:

10 volume parts of nitric acid, 10 volume parts of acetic acid, 40 volume parts of glycerol.

1-5% aqueous solution of hydrofluoric acid

to top

Electrolytic etching

Electrolytic etching is acid etching enhanced by electric current. The etched specimen (anode) is immersed in an acidic electrolyte.

Electrolytic etching is used when the specimen does not respond to conventional chemical etching reagents.

to top

Thermal etching

Thermal etching is a method of revealing structure features by heating the specimen to a high temperature in vacuum or in an atmosphere of a certain gas.

The grain structure ofsome nickel alloys is revealed by heating the specimen in Hydrogen.

to top


Related internal links

etching_metallographic_specimens.txt · Last modified: 2023/12/13 by dmitri_kopeliovich
Promote in SubsTech       Creative Commons License Except where otherwise noted, this work is licensed under a Creative Commons Attribution-Noncommercial-Share Alike 3.0 License