SubsTech     
SubsTech     
Command disabled: index

to Metals
to Titanium alloys

Classification of titanium alloys

Dr. Dmitri Kopeliovich

There are two crystallographic forms of titanium:

Pure titanium exists in form of α-phase at temperatures above 1621°F (883°C) and in form of β-phase at temperatures below 1621°F (883°C).

The temperature of allotropic transformation of α-titanium to β-titanium is called Beta Transus Temperature.

Alloying elements in titanium alloys may stabilize either α-phase or β-phase of the alloy.

Aluminum (Al), gallium (Ga), Nitrogen (N), Oxygen (O) stabilize α-phase.

Molybdenum (Mo), vanadium (V), tungsten (W), tantalum (Ta), silicon (Si) stabilize β-phase.

Titanium alloys are classified into four groups according to their phase composition:

Commercially pure titanium consists of grains of α-phase and dispersed spheroid particles of β-phase. Small amounts of iron, present in the alloys, stabilize β-phase.

Commercially pure titanium has relatively low mechanical strength and good corrosion resistance.

α-alloys consist entirely of α-phase. They contain aluminum as the major alloying element, stabilizing α-phase.

α-alloys have good Fracture Toughness and Creep resistance combined with moderate mechanical strength, which is retained at increased temperatures.

They are easily welded, but their workability in hot state is poor.

Near α-alloys contain small amount of ductile β-phase. Besides α-phase stabilizer (aluminum), near α-alloys are alloyed by 1-2% of β-phase stabilizers (molybdenum, silicon).

Mechanical properties of near α-alloys are similar to those of α-alloys, however due to the presence of β-phase these alloys may be heat-treatable and are forged in hot state.

α-β alloys contain 4-6% of β-phase stabilizers; therefore they consist of a mixture of α and β phases.

α-β alloys are heat-treatable. They have high mechanical strength and good hot formability.

Creep resistance of the alloys is lower, than that of α- and near α-alloys.

β-alloys are rich of β-phase. They contain substantial amount of β-phase stabilizers, preventing β-α transformation at high cooling rates of quenching.

β–alloys are heat-treatable to very high strength and have good hot formability.

Ductility and fatigue strength of the alloys in heat-treated conditions are low.

Titanium alloys are designated according to their compositions:

Ti-5Al-2.5Sn identifies titanium alloy, containing 5% of aluminum and 2.5% of tin.

Ti-6Al-4V identifies titanium alloy, containing 6% of aluminum and 4% of vanadium.

In parallel to this designation system other systems for designation titanium alloys exist (ASTM, IMI, military system).

to top


Related internal links

classification_of_titanium_alloys.txt · Last modified: 2023/12/13 by dmitri_kopeliovich
Promote in SubsTech       Creative Commons License Except where otherwise noted, this work is licensed under a Creative Commons Attribution-Noncommercial-Share Alike 3.0 License